SOLUTION AT Australian Expert Writers
Make the ENSP topology as well and configure it.Unit Network ManagementUnit code CSC73002Assignment 1 Network configuration managementMode Individual assignmentDue Date 10 Aug 2020 11:00 PMLearning Outcomes LO1Graduate Attributes GA4Weight 30% of overall unit assessmentSuggestion This assignment is developmental and cumulative. You are strongly advised to start doing this assignment from Week-3 in your study. Leaving your starting date to the week before the due date is a very poor strategy for success in the unit. Follow the provided marking guidelines to help you successfully direct your efforts.Task DescriptionImagine that you have been employed by XYZ Corporation as a junior network administrator. As part of your duty, you are requested to configure and manage a network lab to perform tests on before they are deployed to the real network. The network lab imitates a typical enterprise network with the Headquarter and two branches connected over the Internet. The high-level logical topology of the network is given in Figure 1 and the physical layout of the offices is given in Figure 2.To study the network before the actual deployment, you will use a network simulator to complete the following tasks:• Task 1: Network simulation. In this task, you will create the network in a simulator from its logical topology and perform all necessary configurations for the network devices to make the network operational. Verify the network connectivity.• Task 2: Configuration management. In this task, you will document the network configurations following the network configuration management practice.Simulation Software:The organisation has 2 (two) enterprise network simulators that you may choose from. 1. eNSP Huawei Network simulator2. Cisco Packet Tracer.Figure 2 The branch physical layoutsAssignment-1 marking guidelinesThe following are the major assessment criteria of this assignment Task 1: Network simulation• Physical network topology o Suitable hardware configuration o Suitable link technologieso Correct physical topology with sufficient notation• Device configuration o Correct IP addressing scheme.o Correct basic administrative configuration i.e. device name, time zone, clock and device access control.o Correct interface configuration i.e. interface IP address and status.• Internetwork routing configurationo Correct configuration of either static routing, RIP or OSPF.o Evidence of the network connectivity verification Task 2: Network configuration management• Document network physical and logical topology with sufficient notation• Document network inventory i.e. detailed network hardware and software• Document current configurations of each device in the network• Configuration change managementFormat and PresentationTask 1: You are required to record a short video clip (5 min max) to explain your task 1. In the video, you will:• Provide your details e.g. your name, student id, year and the unit you are studying• Explain your implementation of the network on eNSP i.e. talk about your selection of the network hardware, link technologies as well as the device configuration.• Demonstrate the network connectivity between the Headquarter and the branches.Finally, publish your video on YouTube. Use the unlisted option if you do not want the video to be viewed in public.Copy the link to your video and paste it under the task-1 section of the document template provided with this assignment.Task 2: Use the template provided with this assignment for this task.Submission FormatYou will need to submit at least 2 files.1. You are required to submit the assignment document in the Word DOC or DOCX or PDF format. The file will be named using the following convention:filename = FirstInitialYourLastName_CSC73002_A1.pdf(i.e. FJones_CSC73002_A1.pdf or FJones_CSC73002_A1.docx)2. Your network configuration, including the optional configuration files if chosen.a. You must also submit your simulation network as either an eNSP or Packet Tracer file.i. eNSP must be a zip file with all devices configured and saved.ii. Packet Tracer files must be a PKT file with all devices configured and saved.b. If you do not put the configuration in the word document you must place them in text files and attach them in the network configuration zip file.Original workIt is a University requirement that a student’s work complies with the Academic Policy, Chapter 4.20 on Student Academic Integrity. It is a student’s responsibility to be familiar with the Policy.Failure to comply with the Policy can have severe consequences in the form of University sanctions. For information on this Policy please refer to Chapter 4.20 on Student Academic Integrity at the following website:http://www.scu.edu.au/governance/academicboard/policy/As part of a University initiative to support the development of academic integrity, assessments may be checked for plagiarism, including through an electronic system, either internally or by a plagiarism checking service, and be held for future checking and matching purposes.Retain duplicate copyBefore submitting the assignment, you are advised to retain electronic copies of original work. In the event of any uncertainty regarding the submission of assessment items, you may be requested to reproduce a final copy.School Extension PolicyIn general, I will NOT give extension unless there are exceptional circumstances. Students wanting an extension must make a request at least 24 hours before the assessment item is due and the request must be received in writing at the -Special Consideration- page.Extensions within 24 hours of submission or following the submission deadline will not be granted (unless supported by a doctor’s certificate or where there are exceptional circumstances – this will be at unit assessor’s discretion and will be considered on a case by case basis). Extensions will be for a maximum of 48 hours (longer extensions supported by a doctor’s certificate or alike to be considered on a case by case basis).A penalty of 5% of the total available grade will accrue for each 24-hour period that an assessment item is submitted late. Therefore, an assessment item worth 20 marks will have 1 marks deducted for every 24-hour period and at the end of 20 days will receive 0 marks.Students who fail to submit following the guidelines in this Unit Information Guide will be deemed to have not submitted the assessment item and the above penalty will be applied until the specified submission guidelines are followed.Marks and FeedbackAll assessment materials submitted during the semester will normally be marked and returned within two weeks of the required date of submission (provided that the assessment materials have been submitted by the due date).Marks will be made available to each student via the MySCU Grade book.
- Assignment status: Already Solved By Our Experts
- (USA, AUS, UK & CA Ph. D. Writers)
- CLICK HERE TO GET A PROFESSIONAL WRITER TO WORK ON THIS PAPER AND OTHER SIMILAR PAPERS, GET A NON PLAGIARIZED PAPER FROM OUR EXPERTS
QUALITY: 100% ORIGINAL PAPER – NO PLAGIARISM – CUSTOM PAPER